Pop-up menus and files
The pop-up menu for memory includes four options in addition to the options common to all components:
- Edit Contents: Bring up a hex editor for editing the contents of memory.
- Clear Contents: Resets all values in memory to 0.
- Load Image...: Resets all values in memory based on the values found in a file using the format described below.
- Save Image...: Stores all values in memory into a file using the format described below.
The file format used for image files is intentionally simple; this permits you to write a program, such as an assembler, that generates memory images that can then be loaded into memory. As an example of this file format, if we had a 256-byte memory whose first five bytes were 2, 3, 0, 20, and -1, and all subsequent values were 0, then the image would be the following text file.
v2.0 raw 02 03 00 14 ff
The first line identifies the file format used (currently, there is only one file format recognized). Subsequent values list the values in hexadecimal, starting from address 0; you can place several such values on the same line. Logisim will assume that any values unlisted in the file are zero.
The image file can use run-length encoding; for example, rather than list the value 00 sixteen times in a row, the file can include 16*00. Notice than the number of repetitions is written in base 10. Files produced by Logisim will use run-length encoding for runs of at least four values.
Next: Hex editor.
